FlexKraft

There are some things that make FlexKraft™ stand out from the crowd: its modular design, the minimized downtime it results in and its neat design.

Our rectifiers live in a tough world

Plating shops and process plants are harsh and unfriendly places.
Therefore our rectifiers must be tough, robust and reliable, so that they can
operate continuously at maximum output. FlexKraft™ is protected from everything, from short circuits to excessive
temperatures. Ripple is low; efficiency is above 90 % and at any load the power factor is +93 %. FlexKraft™ is available with single or dual output and gives you plating power up to 24,000 Amps.

Less downtime equals lower costs

The modular design allows FlexKraft™ to run on reduced power if a fault occurs in one module. Since the rectifier is operated from the front and can be serviced on site by a local electrician, downtime is kept to a minimum This reduces the potentially high costs of a standstill and increases your plant’s availability.

Good things come in small packages

FlexKraft™ is a good choice if you want to lower your costs. The compact, convenient units are serviced from the front, which saves a lot of time.
They can be placed side by side or built on top of each other, making them easy to fit into your plant’s design, thus optimising floor space. Further¬more, they are easy to install and maintain.
Each rectifier consists of up to ten modules and naturally two or more stacks can be connected to allow higher currents (24 kA) and voltages (120 V DC).

The modular design is great news

Thanks to the modular design you only pay for the power you need. Should you need more power later on – simply add more modules.

Main features
The modular design
Small package
Less downtime
Independent settings for currents and voltage
Designed for 24 hour operation at maximum load, at 40 degrees
Allow higher currents (24 kA) and voltages (120 V DC)